Air Conditioning and Refrigeration Systems - Hot Gas Bypass
On many air conditioning and refrigeration systems it is desirable to limit the minimum evaporating pres-sure during periods of low load either to prevent coilicing or to avoid...
Algae: The ultimate in renewable energy
Pond Scum Fuel - By Marsha Walton, CNN: Texas may be best known for "Big Oil." But the oil that could some day make a dent in the country's use of fossil fuels is smal...
Alternative Energy - Harvesting Green Power
Business Week - 11-13-2006 –Farmers are sowing the seeds of an alternative energy future. But how much of the country can we fuel on corn? By Adrienne Carter
Adapting pump capacities to process demand It is often necessary to adapt the pump capacity to a temporary or permanent change ...
Centrifugal Pumps - design, dimensions, & standards
Centrifugal pumps design and dimensions standards Sponsored Links Standards of design and dimensional specifications are necessary to bring unity to centrifugal pumps. Standards...
Centrifugal Pumps - Volute Pump
A centrifugal pump converts the input power to kinetic energy in the liquid by accelerating the liquid by a revolving device - an impeller. The most common type is the volute...
Chiller Control System - City Water Change Over Panel
How can I retro fit a Legacy City Water change over panel to a chiller that was not originaly shipped with one? When a chiller is order with an auto city water change over...
Chiller Installation, Startup, and Maintenance
The attached PDF includes information needed for installation, startup and maintenance of all Legacy Scoll series chillers. PACT, PAC, ES, EST Scroll series systems
Chiller Problems - HTA alarm on chiller startup
Upon start up, (HTA) hi temp alarm received on micro At the time initial startup, the microprocessor compares the process fluid temperature against the high temp alarm (HTA) set...
Chiller Problems - Microprocessor Low Pressure error Low pressure (Lo1 or lo2) error message on microprocessor controller. After power up and compressor start, compressor stops before reaching the SP1 or SP2 set point and the...
Chiller Problems - Water Heating Up
When microprocessor set point (SP1,SP2) is set below 45F, the chiller runs constant and appears to be heating water rather than cooling. Gylcol freeze protection may have been...
For both Buyers and Sellers this site
offers a NO COST, Effective and Easy alternative to
expensive auction sites or resellers who charge commissions. Our goal is to
provide sellers an way to expose their used chiller equipment to a vast numbers
of qualified buyers while giving buyers the ability to locate the equipment they
need as quickly as possible.